Sonarworks SoundID Ref Multichannel w Mic

Sonarworks SoundID Ref Multichannel w Mic, Bundle of Measuring Microphone and Software, For speaker and headphone calibration, Reference sound for speaker setups from stereo to 9.1.6 Atmos systems, Frequency response correction for studio monitors and headphones for the most linear reproduction possible, Enables better assessment of recordings and mixes, Room analysis and automatic room size calculation using numerous measuring points, Audio Calibration Engine for the most accurate adjustment possible, Any number of profiles for speakers can be stored, Provides calibration curves for over 480 different headphone models, Target curves can be individually adjusted in real time, 3 Selectable filter modes: Zero Latency, Mixed and Linear Phase to optimise filter quality and latency for different listening situations, Additional settings for mono, dry/wet and safe headroom, Only available in the app: MIDI mapping for various parameters and user presets for predefined output configurations, Export of calibration profile to supported hardware, Measurement microphone with pre-polarised electret condenser capsule, Frequency range: 20 - 20000 Hz with measurement protocol, Polar pattern: omnidirectional, Sensitivity: 14mV / Pa, Inherent noise: 24 dB, Signal-to-noise ratio: 70 dB, Dynamic range: 106dB, Limiting sound pressure level: 132 dB SPL, Requires 48V phantom power, Connector: XLR 3-pin, Multi-angle calibration curves ...